← All products
Gas
Fast Gas Container Bundle 5K
Small container · up to 5,000 ft³
- ClO₂ deodorizing gas for any confined space up to 5,000 ft³
- Each 20 g Red tablet treats 1,000 ft³



Gas activation & treatment
Gas concentrate will stain if spilled. Never put your nose directly over the gas container. Always wear an appropriate P100 respirator mask, goggles and gloves as advised on the SDS.
- 1Create and/or seal the treatment area so that it is a ‘confined space’ without direct sunlight — close windows, doors, shades etc. Disconnect smoke alarms in the confined space for the treatment period. Put Warning / Do Not Enter signs on doors to the confined space.
- 2Determine the size of the space to be treated and the severity of the odor. Odor types and environments vary significantly and must be evaluated case by case. Select the proper Reset product size for the job (L × W × H = cubic feet).
- 3Remove people, plants and pets from the confined space for the treatment period. Furniture and room contents must be dry (not damp) or fading could occur.
- 4Place the Reset container in the center of the space or, if possible, next to the HVAC return with the system fan ‘on’ for the entire treatment period.
- 5Use 5 oz of water per Reset Red tablet. The container maximum is (5) Red tablets and/or 100 grams total with 25 oz of water. Put a simple aquarium-type or Reset aerator on the side of the container and insert its tube and stone into the water.
- 6Add the Reset tablets/paks to the container and water. Wait 30 seconds for the tablets to begin activating, then turn on the aerator and immediately evacuate the confined space.
- 7Treatment time: the aerator will push the gas into the atmosphere within 30 minutes. The more time the gas contacts surfaces the better — minimum contact time is one hour; for difficult odors, lengthen the contact time up to 24 hours.
- 8After the treatment time completes, air out the confined space before re-entering and re-occupying.
Storage & disposal
- Store this product in the original unopened packaging until ready for use, in a cool, dry, well-ventilated area away from heat or open flame, and out of reach of children.
- Do not leave product in direct sunlight, or expose to temperatures above 120°F (49°C).
- Do not contaminate water, food or feed by disposal or storage.
- Emergency handling: in case of spill, contamination or decomposition, do not reseal the package. If possible, isolate the package and discard it in an open, well-ventilated area.
Precautions & first aid
DANGER: KEEP OUT OF REACH OF CHILDREN. Do not ingest. Reset ClO₂ (chlorine dioxide) is a harmful, corrosive and powerful chemical substance that is a lung and eye irritant. Always use and handle with caution; wear an appropriate P100 respirator mask and goggles as advised on the SDS.
- This product contains an oxidizing agent. Do not mix with acids or chlorine. Avoid any contact with flame or burning materials. Once activated with water, it will produce dangerous levels of chlorine dioxide gas.
- Chlorine dioxide gas is a strong oxidizing agent and is irritating to the respiratory tract. Symptoms of exposure depend on concentration and exposure time; they include lacrimation, headache, vomiting, severe cough, asthmatic bronchitis, dyspnea and even death. Do not inhale chlorine dioxide. Do not allow unprotected persons to be exposed to chlorine dioxide gas. Wear appropriate PPE when working with chlorine dioxide gas.
- Causes moderate eye irritation. Harmful if swallowed, inhaled or absorbed through skin. Avoid contact with skin, eyes or clothing. Avoid breathing vapor. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using the toilet. Remove and wash contaminated clothing before reuse.
- Reset ClO₂ application usage solutions are known to work on tile, marble, stone, steel, plastics, rubber, vinyl, fabrics and wood. Always test the product in a small non-visible section first to make sure there are no unintended effects on your material.
First aid
- Dry product — skin
- Brush off loose product. Rinse skin immediately with plenty of water, then wash the area with soap and water. Call a poison control center or doctor for advice if the issue persists.
- Dry product — eyes
- Hold eye open and rinse slowly and gently with water for 15–20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing the eye. Seek medical attention immediately.
- Dry product — ingestion
- Call a poison control center or doctor immediately for treatment advice. Have the person drink large quantities of water if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person.
- Liquid (activated) — skin
- Remove contaminated clothing. Rinse skin immediately. If irritation persists, obtain medical attention. Wear nitrile gloves with prolonged exposure.
- Liquid (activated) — eyes
- Hold eye open and rinse slowly and gently with water for 15–20 minutes. If irritation persists, obtain medical attention.
- Liquid (activated) — ingestion
- Call a poison control center or doctor immediately for treatment advice. Have the person drink large quantities of water, milk or gelatin if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person.
- Inhalation
- Harmful if inhaled and could cause coughing, headaches, difficulty breathing and pulmonary edema. Always use a NIOSH-approved respirator when exposure is great, or when working with any chlorine dioxide gas application. If inhalation occurs, remove the person to fresh air. If not breathing, call 911 or an ambulance, then give artificial respiration and seek medical attention.
Have the product container or label with you when calling a poison control center or doctor or going for treatment.
SDS — Fast Release (PDF)